Find the small plastic cap on each edge of the sliding door panel near the bottom.
Pella sliding glass door hard to open.
Sliding doors are very heavy very breakable and very expensive this is a two person job.
Because sliding doors don t fold out the way bifold doors do they allow access to only half the width of the opening at a time.
Welcome more light into your home with a pella vinyl fiberglass or wood sliding patio door.
Available in both traditional and contemporary styles find a sliding patio door that best complements your home.
Typically this is the result of dirt or debris inside the sill track.
Over time the sliding glass door track accumulates dirt and grime.
Turn the screw.
Never leave the glass door unattended.
Standard sliding glass doors all have tracks.
First slide open the door completely and remove the head stop.
To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.
The track acts as a guide for the door and also allows roller wheels to help the door run smoothly.
How to adjust the rollers on pella sliding doors.
Sometimes a sliding door sticking can be caused by the door simply being too old and has underwent years of wear and tear.
If that doesn t help you may need to remove the door itself and clean the rollers on the top and bottom of the door.
Lower the rollers by turning the screws in the bottom corners of the door counterclockwise to provide clearances then lift the door and angle the bottom away from the frame to remove it.
First all you need to do is simply give the sliding door track a good scrubbing.
Open your pella sliding door halfway.
If after inspecting the track rollers and alignment and your door is still difficult to open and close it may be time for replacement.
Clean the sliding glass door track.
Be sure to brush down both sides of the track as well as help scrub out the dirt that exists in the middle move the door along the track to expose the front scrub move the door back to the closed position scrub and so on.
This slows down your door considerably.
Sounds like there may be dirt in the tracks.
Pry the caps away with a putty knife to access the roller adjustment screw for each roller.
Then lift the door up and out of the track laying it down carefully across two sawhorses.